2339 International Standard (ISo INTERNATIONAL ORGANIZATION FOR STANDARDIZATION MEKAYHAPOAHAH OPFAHW3ALWR HIO CTAHAAPTW3AWW+ORGANISATION INTERNATIONALE DE NORMALISATION Taper pins, unhardened Goupilles de position coniques non trempees Second edition - 1986-11-01 UDC 621.886.54 Ref. No. ISO 2339-1986 (E) Copyright International Organization for Standardization Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (iSO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technicaf committee has been established has the member bodies for approval before their acceptance as international Standards by the ISO Councit. They are approved in accordance with ISO procedures requiring at least 75 % approvai by the member bodies voting. Internationat Standard iSO 2339 was prepared by Technical Committee ISO/TC 2, Fasteners. This second edition cancels and replaces the first edition (isO 2339-1972), of which it constitutes a technical revision. Users should note that ail Internationaf Standards undergo revision from time to time and that any reference made herein to any other Internationai Standard implies its latest edition, unless otherwise stated. ensewithIso license from IHS Not for Resale Printed in Switzerland INTERNATIONALSTANDARD ISO2339-1986 (E) Taper pins, unhardened Scope and field of application This International Standard specifies the characteristics of unhardened faper pins, with metric dimensions and nominal diameters, d, from 0,6 to 50 mm inclusive. References Iso 2081, Metallic coatings --- Electroplated coatings of zinc on iron or steel. Iso 3269, Fasteners - Acceptance inspection. Iso 4520, Chromate conversion coatings on electroplated zinc and cadmium coatings. Not for Resale