ISO INTERNATIONAL STANDARD 1700 Third edition 1988-10-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION MEXKAYHAPOAHAA OPTAHW3ALWA O CTAHAAPTM3ALMM Cinematography -- 8 mm Type S motion-picture raw stock film 一 Cutting and perforating dimensions Cinématographie - Film 8 mm perfore, type S, vierge -- Dimensions de coupe et de perforation Reference number ISO 1700 : 1988 (E) Not for Resale ISO 1700 : 1988 (E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISo, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISo Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 1700 was prepared by Technical Committee ISO/TC 36, Cinematography. This third edition cancels and replaces the second edition (IS0 1700 : 1981), of which it constitutes a minor revision, the annex having been replaced. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latest edition, unless otherwise stated. International Organization for Standardization, 1988 Printed in Switzerland Copyright International Organization for Standardization vided without license from IHS Not for Resale ISO 1700 : 1988 (E) INTERNATIONAL STANDARD Cinematography - 8 mm Type S motion-picture raw stock film - Cutting and perforating dimensions 1 Scope and field of application This International Standard specifies the raw stock cutting and perforating dimensions for 8 mm Type S motion-picture film. Reference edge 2 Reference E ISo 543, Cinematography -Motion-picture safetyfilm Definition, testing and marking. 3 Dimensions and characteristics B The dimensions and tolerances specified in the table apply to raw stock safety film as defined in ISo 543, immediately after cutting and perforating. If required by usage, the manufacturer should indicate the atmospheric conditions applied to the dimensional control at the time of cutting and perforating. Table - Dimensions Dimension mm in 7,975 ± 0,040 A 0.314 0 ± 0.001 6 4,234 ± 0,010 0.166 7 ± 0.000 4 c 0,914 ± 0,010 0.036 0 ± 0.000 4 D 1,143 ± 0,010 0.045 0 ± 0.000 4 R 0,13± 0,03 0.005 ± 0.001 0 E 0,51 ± 0,05 0.020 ± 0.002 L 423,4 ± 0,40 16.67 ± 0.016 NOTE -- Dimension L represents the length of any 100 consecutive perforation intervals. Figure-8mmTypeSrawstockfilm Copyright International Organization for Standardization d without license from IHS Notfor Resale