ISO INTERNATIONAL STANDARD 11082 First edition 1992-11-15 Certification scheme for welded fabric for the reinforcement of concrete structures Systeme particulier de certification des treillis soudés pour le renforcement des constructions en beton Reference number ISO 11082:1992(E) Not for Resale ISO 11082:1992(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approva! by at least 75 % of the member bodies casting a vote. International Standard isO 11082 was prepared by Technical Committee ISO/TC 17, Steel, Sub-Committee SC 16, Steels for the reinforcement and prestressing of concrete. Annex A of this International Standard is for information only. @ISO1992 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without per- mission in writing from the publisher. International Organization for Standardization Case Postale 56·CH-1211Geneve 20·Switzerland Printed in Switzeriand ii Copyright International Organization for Standardization Not for Resale INTERNATIONAL STANDARD ISO 11082:1992(E) Certification scheme for welded fabric for the reinforcement of concrete structures ISO/lEC Guide 39:1988, General requirements for the Scope acceptance of inspection bodies. This International Standard specifies rules for a certi- ISO/lEC Guide 40:1983, General requirements for the fication scheme for continuous production of welded acceptance of certification bodies. fabric for ordinary reinforcement of concrete struc- tures, in order to verify the conformity with require- ments specified in :product ‘standards such' as ISO 6935-3. 3 Definitions A certification scheme for: continuous production consists of the following stages: For the purposes of this International Standard, the following definitions apply. - suitability testing (see clause 4);: 3.1 . certification scheme: Certification system .as - internal inspection by the manufacturer (see related to specified products, processes or services clause 5); to which the same particular standards and rules, and the same procedure, apply. [ISO/IEC Guide 2] - inspection and supervision by an external body (see clause 6). 3.2 certification body: Body that conducts certi- fication of conformity. [isO/IEC Guide 2] 3.3 characteristic value: Value having a prescribed probability of not being attained in a hypothetical un- limited test series. [ISO 8930] 2 Normative references NOTE 1 Equivalent to fractile, which is defined in The following standards contain provisions which, ISO 3534. through reference in this text, constitute provisions of this International Standard. At the time of publica- 3.4 fabric type: Fabric with wires and wire arrange- tion, the editions indicated were valid. All standards ments of one kind, however with variabile length and are subject to revision, and parties to agreements width. based on this International Standard are encouraged to investigate the possibility of applying the most re 3.5 inspection: Activities such as measuring. ex- cent editions of' the standards indicated below. amining, testing, gauging one or more characteristics Members of IEC and ISO maintain registers of cur- of a product or service and comparing these with rently valid International Standards. specified 'requiremen